Cranking Problems

Do the following to set up for unit test.

1. It is very important that the magnetic pickup is installed

in the bell housing and properly adjusted.

2. Put voltage on 13 and check to see that you have

2 to 15 volts AC on terminals 1 and 2.

3. If you don’t have the voltage in step 2 while the engine

is cranking then you must check and adjust magnetic

pickup. It may be dirty or have a broken wire.

4. If your engine isn’t cranking at all check to see if you

have voltage on terminal 6 when you put voltage to

terminal 13.

5. If nothing is working then do the basic engine test.

After you have done that come back to step 6.

6. Now that you have confirmed engine control operation

be sure you adjust the unit as shown in adjustments

7. If you are getting one second cranks despite your

current crank time setting be sure sw 5 is off

8. Be sure crank disconnect is not set to zero

9. If you never have seen voltage on term. 6 you should

call 317-849-8470 and ask for sales/service and we

will assist you further

Remember this is just for testing. YOU must reset the

control by using the Adjustments guide accessable from

you main engine control page.