Overspeed LED and Overcrank LED on at same time

 

Do the following ...

 

     1. Your system is equipped with two magnetic pickup

         safety systems. Two seconds into the crank cycle the

         magnetic pickup is checked to see if the engine is

         putting out any voltage. When the engine is running

         it is checked to be sure there is a continuous voltage.

         If either case is not true the engine will stop with both

         the Overcrank and Overpseed LEDs on at the same

         time.

     2. These tests help to ensure no starter damage or over

         speed damage.

     3. Be sure that during cranking you have 2 to 15 volts

         on terminals 1 and 2.

     4. If you don’t have it or it is very low try cleaning the

         magnetic pickup. The magnetic pickup is magnetic and

         does collect ground up flywheel shavings. These

         can eventually cause a lowering of the output voltage.

         Also be sure the wiring is ok. If you don’t have at least

         2 volts AC during cranking you must replace the mag

         pickup.

     5. If your wiring is ok and the ouput is correct you could

         see the Overcrank and Overspeed LEDS on at the

         same time if the engine stops for lack of fuel or other

         reason. Fuel problems often cause this fault indication.

    

    

         .

 

         Remember to re-adjust and wire your unit after testing.

Need parts? Order Online = Click Here.

 

 

 

 

 

 

 

 

 

 

 

 

 

Copyright 2020 Engineering Concepts Unlimited Inc.